Mair Flow Sensor -
However, the sensing range will require capability for large turndown if the fluid turndown range is to be realized. 11.6 OTHER PROPOSED DESIGNS A wake oscillation was observed by Mair (1965). With an axially symmetric and streamlined cylinders mair cannot be measured directly it has to be reconstructed based on the measurements of other variables, In contrast to other flow meters, the HFM sensor directly measures the mass flow rate, possesses a wide measurement In stationary condition it holds for the air flow rate into the cylinders ̇m2,air(t)= ̇m HFM (t)= ̇m1(t) (4.1.25) if no If additional gases ̇madd enter the manifold intake, (4.1.12) is valid and the manifold pressure p2 does not only depend on ̇mair,in but also on
̇madd,.see (4.1.16). (4.1.26) Manifold pressure measurement In order to save the air flow sensor, the chargeair can be determined by the Merhverh Methveth + Mairveir M erhvcrli Methveth 'I' Mair(1 veth) where M is the molecular weight of the gas. The mass fraction of ethylene can A reference massflow meter was placed in the middle of the tube. Ethylene was injected just This book combines a comprehensive introduction with an extensive overview of the current state of the art.Leonards A. K., Der maximale Explrationsstrom. Untersuchung der Lungenfunktton bei Gesunden. Acta Alergol., 1966, 21, 99. 39. Lockhart W., Smith D. H., Mair A., Wilson W. A., Practical experience with the peak flow meter. Brit. mcd. J.,
1060 Schematic.view of a modern Diesel internal combustion engine with (HFM denotes hot film air mass flow sensor) Variable geometry turbo charger Exhaust gas recirculation The symbols used in this section are: mair p2 'PI qPI qMI NOx Fig.Wright, B.M., and McKerrow, C.B. : Maximum forced expiratory flow rate as a measure of ventilatory capacity: With a description of a Lockhart, M.B., Smith, D.H., Mair, A., and Wilson, W.A. : Practical experience with the peak flow meter: Brit. (CMAS) : September 1418, 1980 Natural Environment Research Council (Great Britain) J. Blanchard, J. Mair, I. Morrison By joining a flow meter (11) to the rig at this point, maximum flow rate through the first stage was measured.Brit. Med. J., 2, 1041 ~
1047,.1959. Lockhart, W., Smith, D. H., Mair, A., & Wilson, VV. A. : Practical experience with the peak flow meter. Brit. Med. J., 1, 37~ 38, 1960. Tinker, C. M. : Peak expiratory flow measured by the Wright peak flow meter.
Keywords for Mair Flow Sensor :
Related Posts of Mair Flow Sensor :